Elpro Technologies 905U-D User Manual download pdf (Page 35)

Chapter Four Configuration

Page 35 © January 2011

Modifying an existing configuration

If you read a configuration from a module or a saved file, the program will display the

configuration parameters. You can change these parameters, and then program the module

and/or save the file.

4.4.1 Transparent Mode

The default setting of the program is

transparent mode. Select the system

address or use the random value

already selected - if the module is to

become part of an existing system,

then you must select the same system

address as the existing modules. Also

select the group address - only

modules with the same group address

will communicate with each other.

The “Go On-line On Startup” box

will normally be selected for

transparent mode. If you deselect

this, then the module will start-up in

command mode, and will not operate

until the host device sends it a AT

command to go on-line.

Transparent Repeater

When you select a transparent repeater, the program will ask you to enter a second group

address. The repeater will re-transmit messages from the first group to the second group - and

from the second group to the first

group.

A transparent repeater will transmit

data from its host device (if there is a

host connected) using the first group

address, and will only output data to

its host device if the received

message has the first group address.

If the transparent repeater receives a

message from the second group, it

will re-transmit the message but it

will not output the data.

4.4.2 Controlled Mode

If you select any of the controlled

mode options, you will be asked to

select a unit address for the module.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 60 61

Comments to this Manuals

No comments

Elpro Technologies 905U-D User Manual Page 35

Comments to this Manuals

Related products and manuals for Networking Elpro Technologies 905U-D

Related products and manuals for Camcorders Polaroid Studio 4